A flexible connection above the bogie

Look between a passenger train’s bogie and its body and an air spring can appear to be a squat rubber cushion. Its location matters: this is the secondary suspension, separating much of the bogie’s movement from the occupied carriage. Continental describes a low natural frequency that reduces transmitted vibration while permitting relative movement as the bogie turns through curves. The suspension therefore has to carry a substantial load without making the body follow every movement beneath it.

Sources: air-continental

Pressure carries the load; height controls the adjustment

The supporting force depends on air pressure and the spring’s effective area, which need not equal the simple area suggested by its outside diameter. Added passengers change the load the spring must support. A levelling valve senses a mechanical distance through a linkage and admits or exhausts air to restore the intended height; an electronic height sensor can command valves instead. More load can therefore be supported at approximately the same floor height by changing pressure. The system regulates the body’s position rather than demanding one fixed pressure for an empty and a crowded carriage.

Sources: air-firestone

The valve has a deliberate response

A height controller needs a defined response to movement. RTRI’s comparison of two Japanese levelling valves shows two different approaches. The LV-4 includes a neutral zone and a time-delay mechanism; the LV-7 instead restricts airflow near its neutral position. Small or brief movements consequently do not produce the same correction as a sustained displacement. These characteristics also affect body roll during slow passage through curves. The important distinction is between the air spring’s immediate elastic response and the valve’s separate decision about changing its air content.

Sources: air-rtri

Extra volume changes the spring

An auxiliary air reservoir gives the spring a larger working volume. For a given displacement, the change is then a smaller proportion of the total enclosed volume, reducing the pneumatic stiffness. Firestone’s design guide illustrates lower vertical spring rates and natural frequencies as reservoir volume increases. A restricted connection can also provide damping as air flows between volumes. Reservoir size and airflow resistance thus affect ride behaviour even when the external rubber bellows looks unchanged.

Sources: air-firestone

The flexible shape is part of the design

Air springs must accommodate sideways movement as well as vertical compression. Continental distinguishes half-bellows designs capable of substantial lateral deformation from rolling-lobe types suited to confined low-floor bogies. It also combines air springs with rubber-metal auxiliary springs. These are different mechanical packages for different space and movement requirements. A spring that fits beneath a low floor must still allow the required body-to-bogie displacement. Its outline, surrounding clearances and auxiliary components belong to the suspension design, alongside the pressure inside it.

Sources: air-continental

A train supplies the air as a system

The spring also depends on the vehicle’s compressed-air network. Knorr-Bremse describes compressors, drying equipment and distribution pipes serving pneumatic suspension alongside other train functions. This makes air production and treatment part of maintaining the suspension’s intended condition. Demand-driven compressor control can change how air is supplied, while dryers provide clean, dry air to the network. The visible bellows is therefore the last part of a longer chain: air must be produced, treated, distributed and admitted through the levelling equipment before it supports the body.

Sources: air-knorr