The sensitive instrument sits on the seabed
The familiar surface buoy is only one part of a DART system. The bottom package contains the pressure recorder that detects small changes beneath the water column. NOAA describes quartz pressure sensing sensitive to changes smaller than a millimeter of equivalent sea level within the tsunami frequency band. That specification describes measurement sensitivity under the stated conditions, not a claim that every wave of that size automatically produces an alert. The distinction between a measurable signal and an automatic trigger is central to reading DART data.
Sources: dart-sensor
The buoy carries the message to shore
In NOAA’s description of the first operational DART design, an acoustic link carries readings from the bottom recorder to a moored surface buoy. The buoy then relays them through a satellite link to receiving stations and warning centers. This separates the measurement location from the communications equipment visible at the surface. A plot bearing a buoy identifier can therefore represent pressure measured far below it. The system depends on the whole reporting chain, so a missing transmission is not itself a measurement of calm water.
Sources: dart-link
The interesting change is a residual
Bottom pressure also varies with tides and other slower ocean changes. NOAA’s documented detection algorithm estimates that background from recent observations, predicts the expected pressure and subtracts it from the new measurement. The remaining difference emphasizes fluctuations in the tsunami band. A large absolute pressure reading at great depth is consequently not the relevant signal. Nor is a rising tide alone the target. The analysis asks whether a comparatively small departure from the predicted background has appeared in the appropriate range of timescales.
Sources: dart-algorithm
Crossing a threshold changes reporting
The documented algorithm compares the residual with a threshold and switches to rapid reporting when it is exceeded. Its example threshold is chosen with North Pacific background noise in mind, so it should not be mistaken for a universal physical boundary between a tsunami and no tsunami. NOAA also illustrates seismic Rayleigh waves capable of triggering the procedure. A trigger is therefore a reason to transmit detailed observations for interpretation, not sufficient evidence by itself for a specific coastal wave height or damage outcome.
Sources: dart-algorithm
A pressure record constrains a model
NOAA’s tsunami forecasting workflow combines seismic estimates, ocean observations and precomputed propagation scenarios. DART measurements help constrain the source used in the model so that simulated deep-ocean waves match the observed record. This adds evidence about the moving water beyond the initial earthquake description. The resulting forecast concerns such quantities as wave amplitude, arrival time and flow velocity at modeled locations. Those outputs are calculated using observations and a representation of wave propagation; they are not additional quantities directly measured by the bottom pressure sensor.
Sources: dart-forecast
Keep the observation and coastal forecast distinct
An offshore observation and a coastal forecast refer to different places and stages of the wave’s travel. NOAA’s system uses propagation and inundation modeling to connect them, selecting scenarios that fit the measured tsunami. When reading a chart, distinguish the station record, the fitted model and the location-specific forecast rather than treating one curve as all three. This preserves what DART contributes: a measured check on a developing event. The record is an input to official assessment, not a standalone conclusion about conditions along an entire coastline.
Sources: dart-forecast