Teeth create another path for traction
A conventional driven wheel transmits its pull through adhesion at the running rail. A rack railway adds a pinion, a rotating toothed wheel, that meshes with teeth along the track. The tooth faces carry the longitudinal force, giving the vehicle another traction path. Stadler’s MRS freight locomotives provide a substantial example: their route includes a roughly ten-kilometre rack section with a three-lamella Abt rack. The force still passes through the vehicle structure and rack support; toothed engagement changes how it reaches the track.
Sources: rack-mrs
The gear geometry has to retain engagement
A rack is only useful while the pinion remains correctly meshed with it. ASME’s technical account of the Pilatus railway explains why Eduard Locher turned the rack’s working faces sideways and used opposed horizontal cogwheels. This arrangement addressed the possibility of a conventional cogwheel climbing out of its rack on the very steep route. It illustrates a broader mechanical point: a gear mesh produces forces that the surrounding structure must resist. Designing the teeth and designing the restraint that keeps those teeth together are inseparable tasks.
Sources: rack-asme
Guidance can be built around the rack
Locher’s arrangement also uses flanges beneath the horizontal cogwheels. ASME describes these running along the rack support and underneath the rack, providing guidance and resisting lift that could disengage the teeth. This does more than add a powered gear above a centre rail. The rack assembly participates in locating the vehicle as well as transmitting drive. The mechanism contains several working surfaces: tooth faces carry drive, while the associated guiding and retaining features control the relationship between vehicle and track.
Sources: rack-asme
A gradient percentage is not an angle
Pilatus-Bahnen states a maximum gradient of 48 percent for its railway. That means 48 units of vertical rise for 100 units of horizontal distance, equivalent to an angle of approximately 25.6 degrees. This conversion is a geometric calculation, not another operating specification. It helps explain the scale of the uphill force: a substantial component of the vehicle’s weight acts down the slope. The operator also publishes different uphill and downhill speeds, showing that the same track can impose different limits depending on the direction of travel.
Sources: rack-pilatus
Some locomotives combine rack and adhesion
Stadler’s MRS example combines rack-and-pinion and adhesion equipment in one locomotive. Its datasheet lists two independently powered drive units and specifies the Abt rack geometry. It also notes that the locomotive occupies the downhill side of the consist because the trailing vehicles have no rack brake. These features belong to that freight design. They reveal an important system boundary: a rack-equipped locomotive does not automatically make every connected wagon a rack-braked vehicle. Train formation and the distribution of braking capability remain part of the design.
Sources: rack-mrs
Descending speed depends on the brake system
A positive tooth engagement is not a complete answer to downhill braking. The vehicle must also absorb or recover energy and achieve the required stopping performance. In March 2025, Stadler and Matterhorn Gotthard Railway reported a new ORION rack-braking system authorized for up to 30 km/h downhill on a 181-per-mille gradient, compared with the previous 21 km/h limit for that case. The announcement attributes the change to increased braking capability. It is a specific engineering example of a speed improvement coming from the stopping system, rather than additional climbing power.
Sources: rack-orion