Start with the receiving train

Regenerative braking converts some of a slowing train’s kinetic energy into electricity. JR East describes using that electricity to power nearby trains. The second train is an essential part of this example: energy recovered by one vehicle becomes useful because another vehicle needs power. An illustration with arrows leaving a braking train should therefore prompt a further question: where do those arrows end, and is that destination able to accept electricity at that moment?

Sources: RB1

If a suitable powered train is absent, JR East explains, regeneration can raise the feeding voltage. Once a prescribed level is reached, regeneration is suppressed to protect equipment. The ability to generate during braking does not guarantee that all available braking energy will be recovered. The electrical supply system has to accommodate the exchange.

Sources: RB1

Stopping and recovering energy are different requirements

RTRI’s October 2022 Ascent article describes how DC-fed trains generally reduce regenerative braking effort as the contact-line voltage approaches its limit. Mechanical braking supplies the required braking effort instead. That distinction prevents a misleading interpretation of suppressed regeneration: the issue described here is the opportunity to reuse energy, while the braking system still has to provide the demanded deceleration. The article addresses DC railway operation; its details should not be assumed to describe every electrification system.

Sources: RB2

Storage and conversion provide other destinations

The same RTRI account identifies stationary energy-storage systems and regenerative inverters as ways to improve utilization. Storage retains energy for later reuse, whereas an inverter can direct regenerated electricity toward station loads such as lighting and escalators. In a project description, look for whether energy is being shifted to a later time or delivered to another kind of electrical load.

Sources: RB2

Storage also requires coordination. RTRI’s 2024 research investigated controlling fixed and onboard storage together, distributing charging and discharging requests while seeking to balance their states of charge. Test-track work with a single trainset demonstrated controlled charging under an assumed surplus of renewable electricity, alongside charging from another vehicle’s regenerative power when needed. This is a research demonstration of coordinated use, not evidence that every railway battery already participates in such a system.

Sources: RB4

A timetable can change the electrical match

There is another way to improve the exchange: change when trains need or return power. RTRI’s 2023 timetable research first adjusted running times between stations while preserving each train’s total journey time. It then adjusted arrivals and departures to increase the overlap between powering and braking. The method could accommodate constraints such as transfers, speed limits and signalling headways. The timetable becomes part of energy management.

Sources: RB3

In a simulated metropolitan case covering more than 400 trains, the researchers reported a 4.4 to 7.5 percent reduction in energy supplied by substations relative to the existing timetable. For any proposed saving, ask for the baseline, operating pattern and measurement boundary before comparing percentages. A vehicle’s recovery figure and the electricity supplied to a whole railway are not automatically interchangeable measures.

Sources: RB3